The design screen can be customized to make application creation more comfortable. This section describes the customization of the design screen.
Work area/property area sizing
You can adjust the work area and property area to the size you are comfortable with.
To resize the work area, move the pointer over the blue line in the figure below and drag left or right.
To resize the properties area, move the pointer over the green line in the figure below and drag up or down.
Information area display
Various logs can be checked in the information area*.
To display the information area at the bottom of the screen, click the middle button of the three display setting buttons in the upper right corner of the screen. To hide, click again. To switch between log types, click on each tab.
The types of logs are as follows
| Log Type | Description. |
|---|---|
|
output (e.g. of dynamo) |
Error messages are displayed when a serious error occurs. |
|
system |
When an error check is performed on an open project, |
|
debug log |
You can check the debug log. Note that the debug log can be viewed at the top of the screen by clicking on the |